old revision restored (2025/07/03 16:23)
tc-25
Table of Contents
Creating a trip and checking that the data is stored and displayed correctly
Preliminary actions.
Before you create a trip, you must create one or more loads that will be included in the trip. At the same time, they need to check the box “LTL Partial”
Remember the selected Driver 1, Trk/Unit and Trailer (to check their change)
Create a trip.
Action: Open the “Load Planning” tab
Press LTL
Excpect: A window will be displayed with 2 grids: the top one contains all loads that have the “LTL Partial” attribute, but are not yet associated with trips. The bottom one contains all previously created trips.
tc-25.txt · Last modified: 2025/12/13 10:10 by 216.73.216.58
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
