Differences

This shows you the differences between two versions of the page.

--- tc-9 [2025/12/15 14:36]
216.73.216.58 old revision restored (2022/01/06 18:10)
+++ tc-9 [2025/12/15 14:40] (current)
216.73.216.58 old revision restored (2025/02/19 05:44)
@@ Line 1: / Line 1: @@
-==Require Carrier Pay on All Loads==
+====Require Carrier Pay on All Loads====
 //Introduction:// The user can put a setting in Brokerage Preferences to Require Carrier Pay on All Loads.
@@ Line 5: / Line 5: @@
 **Action:**
 Go to Brokerage Dispatch --> System --> Settings --> Brokerage Preferences --> Require Carrier Pay --> Close.
 How it should look like:
-{{:require_carrier_pay_on_all_loads.png?nolink&400|}}
+{{:require_carrier_pay_on_all_loads.png?nolink|}}
 __Expected Result:__
@@ Line 15: / Line 17: @@
 User will see that if Carrier Pay = 0, then the program will show a message, that offers her\him to set up the amount.
-{{:carrier_pay_is_required.png?nolink&400|}}
+{{:carrier_pay_is_required.png?nolink|}}
-If the user set Yes, then he\she will receive the set form.
-{{:carrier_pay_form.png?nolink&400|}}
+If the user hits No, then the program won't allow him\her to assign the Carrier. If the user hits Yes, then he\she will receive the set form.
+{{:carrier_pay_form.png?nolink|}}
+After the user sets and hits OK, he\she will see that Carrier Pay will be set to the desired amount and won't be equal to 0.
+{{:carrier_pay_equal_amount.png|}}

DRD Test cases